Posted on

Bill Installed 525UF On His 2006 Club Car

Joe, Finished my 525UF gungrabber install in my 2006 club car golf cart. Turned out pretty good and I really like the product. 

Did have one issue with the install, the kit was missing the 1/4” black nylon nuts. Luckily, I had a enough spares since club car uses them in a number of places and I had spares. Anyway, made a few changes. 

Since the floor slopes backwards, I made a plastic ramp using a ‘post to concrete plastic base’ from Lowe’s and cutting a slope on the plastic piece. Worked very well but also needed to change the bolts to 2” and 2.5” to reach through the floor. Since I am not great with a drill, I drilled your back plate to 3/8” holes to give me slop for my work .

 For stability, I found a strap a Lowe’s that I cut down, painted and then JB weld to the side of unit and bolted through the dash. 

Lastly, I changed your 2” bolt for height and replaced with a tractor pin. Allows me to adjust height very quickly whether using the cart for skeet or hunting with rifles. Anyway, hope this long email gives you a few ideas or suggestions for someone else’s install. This is a great product. Well thought out and designed. 
Bill 

I really like the idea of the removable pin. Thanks Joe.

Bill we took your idea and put it into action. Our new 525 UF the top portion of the unit can now be removed and the mounting stud is covered with a rubber cover for protection. Thank you sir great idea. Oh we also have our 525UF in Over and Under Single or Double and our 525UF Single or Double 310VT for rifles single barrel shotguns.

bill1
bill2